Cupra Ateca Lowering Springs
These RacingLine Sport Lowering Springs have been carefully developed for the Cupra 2.0 TSI 4Drive model, meaning that your Ateca will still ride beautifully yet with a noticeably more dynamic handling edge. They give a drop of around 30mm front and rear – the perfect ride-height without those SUV wheelarch gaps. In other words, just how it should have come from the factory.
RacingLine’s Sport Springs replace the car’s four stock springs with re-engineered, progressive-rate and slightly shorter Sport Springs. The springs lower the Cupra Ateca by around 30mm front and rear (depending on exact model and spec) in order to preserve the wheel travel needed for ideal ride & handling. Go lower or stiffer than RacingLine’s springs and your car tends to bounce and crash as the dampers are mismatched to spring-rate, and the springs themselves run out of travel.
The result? The vehicle’s high center of gravity is lowered, reducing body roll for better dynamics, whilst maintaining the ride quality and comfort of your car.
Meanwhile, the car’s SUV appearance is subtly transformed. By getting rid of those nasty SUV wheelarch gaps, it’ll look like it always should have from the factory!
RacingLine’s extensive development program has specified progressive rate springs to preserve the ride quality in normal use, but then stiffen the rates at the ends of the travel. This progressive-rate spring construction means the spring rate in the middle of travel is very similar to standard. It’s only towards the end of the spring’s travel (so, when braking or cornering hard) that RacingLine have engineered the spring to stiffen up. It’s this progressive-rate spring design that is the secret to such good ride quality combined with dynamic performance.
Developed to be fully compatible with cars fitted with Cupra’s switchable DCC (adjustable chassis control) dampers.
Not suitable for 2WD vehicles.