DBA T2 Street Series Rear Brake Disc – 262mm (Pair) – DBA3659S

DBA T2 Street Series Rear Brake Disc – 262mm (Pair) – DBA3659S

The DBA T2 Series front brake discs are a straightforward, quality upgrade over standard replacement rotors. Made by DBA (Disc Brakes Australia) – a well-respected name in performance braking – these 262mm discs are designed to deliver reliable, consistent stopping power for everyday driving and light performance use.

If your current discs are worn, warped, or simply due for replacement, the T2 Series offers a meaningful step up in both performance and durability without going to the extremes of a full motorsport setup.

What Makes the T2 Series Different?

The T2 disc features DBA’s slotted rotor design. Slots are machined grooves cut across the face of the disc. As you brake, heat and gas build up between the pad and disc surface – this is normal, but if it is not managed, it reduces braking effectiveness. The slots allow those gases to escape, keeping the contact surface clean and consistent.

The slots also help remove any glaze (a hardened layer that can form on brake pads over time) from the pad surface, keeping the braking bite more consistent over the life of the discs.

• Slotted rotor design for improved gas dispersal and pad surface condition
• 262mm diameter – suited to vehicles with larger front brake setups
• Sold as a pair – both left and right discs included
• Manufactured from high-quality iron for strength and thermal resistance
• Paint protection on non-friction areas to reduce surface rust and improve appearance
• DBA’s trusted manufacturing quality, backed by extensive testing

Real-World Performance

For the majority of drivers, the T2 Series will provide a noticeable improvement in pedal feel and braking consistency compared to budget or worn standard discs. They are well suited to spirited road driving and light track use, though drivers regularly pushing hard on circuit may want to consider DBA’s T3 or 4000 Series for higher heat demands.

Brake discs work best when paired with quality brake pads. If your pads are also worn or not well matched to the disc material, consider replacing both at the same time for the best result.

Fitment

These discs fit a range of vehicles requiring a 262mm front rotor. Please use the vehicle lookup tool on this page or check the “Vehicle Fitment” tab to confirm these discs are correct for your specific make, model, and year before ordering. Fitment can vary depending on brake caliper type and trim level, so it is important to verify compatibility before fitting.

Important: As with all new brake discs, a bedding-in procedure should be followed after fitting. This involves a series of gentle, progressive stops from low speed to allow the pad material to transfer evenly onto the disc surface. Skipping this step can reduce braking performance and shorten the life of both the pads and discs. Refer to DBA’s recommended bedding-in procedure or consult a qualified mechanic